Working principle

The working principle of vertical circulation mechanical parking equipment is that the motor drives the transmission mechanism through the reducer, and the traction component-- on the chain, every otherSegmentA vehicle storage bracket is installed at the distance. When the motor is started, the vehicle storage bracket moves vertically with the chain to achieve the purpose of accessing the vehicle.

1.Land-saving: small footprint, a single group of equipment covers an area of about2.5Parking spaces (about36㎡), can accommodate12-20a vehicle;

2.Convenient: easy to operate and usePLCControl automatic shunting, access to the car can be completed by one button;360Degree rotation, in order to achieve the effect of the vehicle forward storage, forward out of the warehouse.

3.Quickly: The system will intelligently control the rotation direction of the equipment according to the position of the car board, and pick up the car nearby, and the speed of picking up the car is fast;

4.Energy saving: a single group of equipment only one to two drives, power consumption bottom. on the seventh floor12Take the parking space as an example, the power consumption of the farthest vehicle is only0.4Degree, take the nearest vehicle power consumption is insufficient.0.1degree;

5.Economy: covers a small area, save land investment costs, and the foundation, exterior investment less;

6.Reliable: this kind of equipment has simple structure, high safety, high reliability and low failure rate;

7.Short cycle: Under the premise of complete goods, the entire installation process of a single set of equipment can be completed within a week.

Operation process

1.Receipt process:

Step 1: The incoming vehicle drives to the front end of the garage entrance and exit, and other people in the vehicle get off except the driver.

Step 2: The vehicle slowly drives into the vehicle carrier, and adjusts the position of the vehicle body through the front auxiliary mirror to ensure that there is no obvious deviation between the center of the vehicle and the center of the vehicle carrier. Stop when the front wheel of the vehicle touches the vehicle blocking device.

Step 3: Turn off the flame, pull the handbrake, the driver gets out of the car, closes the door, retracts the rearview mirror, and then leaves the garage area

Step 4: Enter any empty car plate number on the man-machine interface (preferably one car plate spaced from the current car plate), and press“RUN"key, the current car board rotates on the ground180To achieve the vehicle turn, and then the car plate cycle operation, you can complete the storage of the car.

If the operation mode is touch screen, the fourth step: input the license plate number of the vehicle to be stored in the touch screen, and press the vehicle storage key to complete the vehicle storage.

2.outbound process:

Step 1: Enter the number of the vehicle board on the man-machine interface, and press“RUN"key, the device runs (if the operation mode is touch screen, enter the license plate number entered when storing the car on the touch screen, and press the pick-up key)

Step 2: When the target car board runs to the entrance and exit and the equipment stops running, the driver enters the garage area, opens the rearview mirror, and enters the vehicle

Step 3: Start the vehicle and drive out of the garage

Note: When operating the equipment, ensure that there is no one in the garage area. During the operation of the equipment, personnel are prohibited from entering the garage area.